ITEM 测试项目 |
TEST METHODS 测试方法 |
Dimensions外形尺寸 |
Using vernier caliper (accuracy≥0.02) while avoiding short-circuit.One end of the caliper should be coated with an insulating material. 用精度不低于 0.02mm 游标卡尺测量,测量时防止电池短路,卡尺的一端卡头上应贴上一层绝缘材料。 |
Off-load voltage 开路电压 |
Using multimeter (accuracy≥0.25%) internal resistance≥1MΩ. 用精度不低于 0.25%,内阻不小于 1MΩ万用表测量。 |
Instantaneous short-circuit current 闭路电压 |
Before the test, the battery should be placed under the condition of 20±2℃、RH60±15% for more than 8 hours, and then measured at the same temperature Time of short-circuit should be less than 0.5 second and avoid repeated test within half an hour. 测试前电池需在 20±2℃、RH60±15%条件下放置 8 小时以上,再在同样温度下测量。用万用表测量时,每次测量时间不超过 5 秒,避免重复测量,若需再次测量时,时间间隔应在半小时以上。 |
Appearance 外观与极端 |
Eyeballing 目测检查 |
Discharge time 放电时间 |
Taking nine cells under the condition of 20℃±2℃、RH60%±15% place more than 8 hours, at the same temperature and humidity conditions for 30 k Ω resistance to 2.0 V, the average continuous discharge the battery discharge time should be within 60 days after the production, storage electric should be carried out within 14 days after the expiration of the storage 取9只电池在20℃±2℃、RH60%±15%条件下放置8小时以上,在相同温湿度条件下用30kΩ电阻连续放电至2.0V时的平均放电时间。电池应在生产后60天内进行,贮存电应在贮存期满后 14天内进行。 |
供应LIYUA牌子CR2450HT扣式锂锰宽温电池
产品编号:100036068
修改时间:2021-06-18 11:58 发布IP:115.153.92.79 访问统计:1次
|
推荐产品
供应LIYUA牌子CR2450HT扣式锂锰宽温电池
免责声明:"供应LIYUA牌子CR2450HT扣式锂锰宽温电池"由宁夏晟腾达贸易有限公司自行提供,真实合法性由发布企业负责,环球贸易网对此不承担任何保证责任。
您可能喜欢